Solvent-based: films with this kind of adhesive are resistant to aging and are convenient for the end-user to remove, produced using acrylic acid and an organic solvent Rubber-based: with a high cohesion and little residual glue, rubber-based adhesive is perfect for protective film applications and can use both natural and synthetic rubber 6. Scrape off the heated epoxy with a plastic scraper. Use a strong, plastic scraper to remove the epoxy from the surface. You may notice that the heat did not penetrate all the way down into all of the layers of epoxy. In this case, keep reheating the area and scrape until all the epoxy has been removed. Lay the sheet on a flat surface and, using a yardstick and a permanent marker (or a grease marker), measure and draw the line you wish to cut. Next, hold the yardstick to the marked line, and run 3. I forgot to remove the plastic protective film from the outside of a metal door. The door is white prime/painted. I was able to remove the film from the inside of the door, but the outside is baked on and cracked. I have tried using a metal paint scraper, but the plastic is very resistant to that. I have tried soaking it in water, spraying - The protective liner has been printed by the customer. - The film has a heat-activated adhesive. Applied Graphics: On Panels, Sheet Metal, Plastic Sheet, etc. • Protect each layer with 3M™ Easy Release Liner SCW-33 so the shiny side faces the printed graphic. • If the substrate has been printed or decorated on two It may take the hight gloss finish out of the profile depending on how much fluid is needed to thin the tape to remove it. Your other option is to pick at it for days and days I should of probably said that iv been cleaning ,repairing and recolouring plastic for over 10 years .Speaking with a lot of experience (mr handy bandit ) I bought a bunch of clear acrylic sheet from my local plastics wholesaler at a great price because it was old stock and they said the protective paper would be difficult to remove. They recommended something with a mild acid pH, lemon juice or vinegar. It didn't work. I tried a number of things, but finally had the most success with this method: She said they use 3M Citrus Based Adhesive Remover to get the years old labels off chemical storage bottles. Sprayed some on, wait a few minutes, used beveled Plexiglas scraper to start lifting the paper, and it pealed the paper in sheets. OK, edges where the paper had lifted over time, and the glue had turned rock solid wasn't touched. BEST FOR OUTDOOR USE: 3M Outdoor Window Insulation Kit. BEST FOR LARGE WINDOWS: 3M Indoor XL Window Insulation Kit. BEST INSULATION TAPE: Yotache Weather Stripping Foam Seal Tape. BEST FOR zEc1FW.

how to remove old protective film from acrylic sheet